Commit 13078454 authored by Ralph Giles's avatar Ralph Giles

Apply further fixes from Ron.

parent 1204ed1b
......@@ -330,7 +330,7 @@ In the example above, if the previous frame was a 20 ms SILK mode frame,
gap.
This also requires four bytes to describe the synthesized packet data (two
bytes for a CBR code 3 and one byte each for two code 0 packets) but three
bytes of Ogg lacing overhead are necessary to mark the packet boundaries.
bytes of Ogg lacing overhead are needed to mark the packet boundaries.
At 0.6 kbps, this is still a minimal bitrate impact over a naive, low quality
solution.
</t>
......@@ -349,7 +349,7 @@ Since medium-band audio is an option only in the SILK mode, wideband frames
There is some amount of latency introduced during the decoding process, to
allow for overlap in the CELT mode, stereo mixing in the SILK mode, and
resampling.
The encoder introduces additional latency through its own resampling
The encoder might have introduced additional latency through its own resampling
and analysis (though the exact amount is not specified).
Therefore, the first few samples produced by the decoder do not correspond to
real input audio, but are instead composed of padding inserted by the encoder
......@@ -364,7 +364,7 @@ However, a decoder will want to skip these samples after decoding them.
A 'pre-skip' field in the ID header (see <xref target="id_header"/>) signals
the number of samples which SHOULD be skipped (decoded but discarded) at the
beginning of the stream.
This amount MAY not be a multiple of 2.5&nbsp;ms, MAY be smaller than a single
This amount need not be a multiple of 2.5&nbsp;ms, MAY be smaller than a single
packet, or MAY span the contents of several packets.
These samples are not valid audio, and SHOULD NOT be played.
</t>
......@@ -804,7 +804,7 @@ For channel mapping family&nbsp;0, this value defaults to C-1 (i.e., 0 for mono
</t>
<t><spanx style="strong">Channel Mapping</spanx> (8*C bits):
This contains one octet per output channel, indicating which decoded channel
to be used for each one.
is to be used for each one.
Let 'index' be the value of this octet for a particular output channel.
This value MUST either be smaller than (M+N), or be the special value 255.
If 'index' is less than 2*M, the output MUST be taken from decoding stream
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment