There is also no trailing whitespace.

xiangmingzhu authored 10 years ago and Jean-Marc Valin committed 10 years ago

1. Only for fixed point on x86 platform (32bit and 64bit, uses SIMD
   intrinsics up to SSE4.2)
2. Use "configure --enable-fixed-point --enable-intrinsics" to enable
   optimization, default is disabled.
3. Official test cases are verified and passed.

Signed-off-by: Timothy B. Terriberry <tterribe@xiph.org>

Considers the case where one stream would eat up all the remaining bytes,
including a 2-byte size that would then not leave enough for the even a PLC
packet in the next streams.

Limit now at 2*streams-1 and anything below that returns OPUS_BUFFER_TOO_SMALL
rather than OPUS_BAD_ARG

OPUS_AUTO should now work fine, while using OPUS_BITRATE_MAX would still
be a bad idea for controlling CBR rate for multistream. The encoder should
now throw an error early on if max_data_bytes is just too small to do anything.

Use abs(sweep_bps) instead of fabs(). "sweep_bps" is an integer,
and on some compilers this line generates a warning.

Patch from Tina le Grand.
Reviewed by Jean-Marc Valin

Mark Harris authored 11 years ago and Jean-Marc Valin committed 11 years ago

Broken by 306d7f5a

Mark Harris authored 11 years ago and Jean-Marc Valin committed 11 years ago

Signed-off-by: Jean-Marc Valin <jmvalin@jmvalin.ca>

This was causing pseudostack builds to fail because opus_demo uses a 2-second
buffer.

We only keep when concealing less than 10ms with SILK.

Thanks to Kevin O'Connor for reporting this.

This is a bit faster at -O2 because memcpy()/memmove()/memset() are
vectorized. The code is also cleaner.

NaN detection should now be able to catch values that would create NaNs
further down.

This also splits the rate adjustment between SILK and CELT (previous
code only changed SILK)

Still needs more tuning

Timothy B. Terriberry authored 11 years ago and Jean-Marc Valin committed 11 years ago

Signed-off-by: Jean-Marc Valin <jmvalin@jmvalin.ca>

Mark Harris authored 11 years ago and Jean-Marc Valin committed 11 years ago

Signed-off-by: Jean-Marc Valin <jmvalin@jmvalin.ca>

These are all completely untested.

Timothy B. Terriberry authored 11 years ago and Jean-Marc Valin committed 11 years ago

Optimizing celt_pitch_xcorr()/xcorr_kernel() which also speeds up
FIRs, IIRs and auto-correlations

Signed-off-by: Jean-Marc Valin <jmvalin@jmvalin.ca>

Works by turning off pitch and energy prediction in CELT, while
setting first_frame_after_reset in SILK to disable pitch and LSF interpolation
and reduce LPC gain.

The problem was that forcing CELT-mode for low bitrate CBR was done too late,
after the encoder had decided to use SILK. This was causing redundancy
to be allocated because the encoder didn't realize it was going to keep
using CELT.

Padding is now handled by the repacketizer.